Madallaadur

Fliegl DTL 300 Agrar

Further information
Chassis low loader trailer
Welded steel construction
Turntable with powerful ball bearing slewing ring
Folding rear support
2 wheel chocks with holder
Rear spray flaps across the entire width
Preparation for widening to 3,000 mm (holes in the outer frame and not in the rear slope)
Low loader lashing eyes
1 pair of lashing cut-outs in the front side member on offset, 10 tons each
7 pairs of lashing points at the top and sides of the outer frame, 10 tons each
1 x front on offset
5 x in the drop deck
1 x in the rear slope
Hjdpfji Ri Agjx Abfeng
12 pairs of lashing holes in the outer frame, each with 5 to. (lashing strap attachment)
5 x crank, 6 x low bed and 1 x in rear slope
Trailer drawbar Turntable
Drawbar with tested 40 mm drawbar eye
Axles + suspension
Drum brake axles, at the manufacturer's choice
Axle/chassis laser-measured Reduction in tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load compensation (rocker compensation)
Wheels and tires
235 / 75 R 17.5 Fulda
Twin steel rims, factory silver
Brake system
2-line compressed air brake system
Spring-applied parking brake
2 non-interchangeable clutch heads at the front, with connecting lines to the motor vehicle,
Connecting lines extended by approx. 60 cm
without ABS, but with mechanical ALB, then max. 60 km/h approval
Electrical system
12 volt, multi-chamber lights, without amber LED lighting at the sides, reflectors at the sides
2 white position lights at the front
2 white/red lane departure lights at the rear
1 x 7-pin 12 volt plug at the front, with connecting cable, extended by approx. 60 cm
1 LED rotating beacon with holder, switched via parking light (removable light)
2 pairs of warning signs, illuminated and extendable to 3,000 mm,
floor
Front offset with steel/ checker plate covering
Storage box recessed in drive-over slope to the offset
Then with 70 mm softwood floor, steel/ checker plate covering in the wheel arch area
Rear slope with 70 mm softwood floor
Deep loading area incl. rear slope 5900 mm
Drive-on ramps
Steel ramps 2 800 mm long, 750 mm wide, can be moved sideways
covered with wood
with spring lift support
Operating instructions
With an axle load of 10,000 kg, a special permit is required, only indivisible loads possible!!!
The specified total weight is technically possible; depending on the load, the total weight may not be reached if the permissible axle/support and fifth-wheel loads are observed. (Poor driving and trailing behavior possible due to incorrect load distribution)
Country of registration / plates
Country of registration: Germany
with Dekra approval and expert opinion, for max. 60 km/h registration, towing vehicle LoF, (max. 40 km/h possible in Switzerland)
Prepared for two-line license plate holder
without contour marking / reflective strips according to ECE R 048,
Paint finish
Frame DB 7350 nova gray
10-year warranty against rusting through
Drawbar Galvanized or black, manufacturer's choice
Drive-on ramps Hot-dip galvanized
Attention: Archive pictures!

Kuulutus tõlgiti automaatselt. Tõlkevigu võib esineda.