Hüdarooliline press

Steiner DHP 800

The STEINER hydraulic press was manufactured and developed with practical aspects in mind. The hydraulic device is located on the hydraulic tank behind the press. Control blocks and valves are easily accessible from the outside and can be quickly replaced if necessary. The hydraulic radial piston pump is located on the drive console and is connected to the motor and pump mount via a coupling. The press stand is indestructible and torsion-resistant
Sthal welded construction. The ironing board is screwed to the stand. The hydraulic cylinders are screwed to the press stand from above and guided through the mounting holes in the appropriate direction. The piston is connected to the piston rods via a wear ring. Four-sided, diagonal, flat grooves on the stand allow for very precise movement.
Hydraulic cylinders are made of high quality material and are designed for high pressures. The piston rods are ground and hard chrome plated. The cylinder tubes are honed from the inside. Seals that have been maintained over many years are characterized by high quality and tightness. The piston rods are guided by guide bands, which are characterized by very low abrasion and a long service life. The control, control and monitoring devices for all control devices are installed in the control unit. Mutual locks ensure that no two program processes can run at the same time. The electrical control is located in a closed control cabinet.
Gbodpfx Afopgktcszei
Pressing force - 8000 kN
Operating pressure - 285 bar
Installation height - 850 mm
Stroke - 250 mm
Table surface - 1550 x 1450 mm
Ram surface - 1550 x 1450 mm
Stand passage - 1800 mm
Lateral Breakthrough in the stand on the right and left
Width x height - 1300 x 1075 mm
Table top thickness - 155 mm
Width of the machine approx. - 3100 mm
Depth approx. - 4300 mm
Height approx. - 4660 mm
Table height above hallway - 500 mm
Table height under hallway - 755 mm
Drive power - 55 kW
Oil requirement approx. - 1400 liters
Total weight approx. - 60 tons