Konteineršassi poolhaagis

Fliegl SDS 380 für 20 Fuß light mit 725 mm Überhang

Custom-Made Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer needs.

Chassis, Saddle, Container
Fine-grained steel welded construction, saddle plate with 2 replaceable kingpins
Container receptacles:
1 x 20 ft in the center (or swap body container 7.15 / 7.45), not retractable at the front, the pivot pins of the container locking mechanism in the longer version
24 tons, two-stage support jacks, single-sided operation
With anti-splash flaps according to EC standards
Front axle drip tray with 1 1/4 inch drain pipe + 1 1/4 inch shut-off valve, including drip pan, with perforated tread plates, approx. 400 mm wide, left + right between the drip tray and the longitudinal beam
4 hose racks, approx. 4500 mm long (hose box) for hose pipes, 2 x DN 200 on the outside + 2 x DN 160 arranged in the center, at the rear hose box (stainless steel) 300 mm deep, splash-proof, lid (stainless steel) all around with rubber seal, with drain hole at the lowest point, then without lid on the hose pipes
1 stainless steel grounding lug at the rear on the right side of the frame, with international grounding sticker on the frame
Climbing steps at the rear right on the underrun protection, at the rear right on the outside of the main beam, tread plate approx. 260 mm long and 300 mm wide
Ksdpfx Aoi Rixkjlfodp
Axles + Suspension
SAF disc brake axles
Axle/suspension laser-measured for reduced tire wear and fuel consumption
Offset axle spacing (combined transport) up to 44 tons total train weight
Air suspension
1st axle: automatic lift axle, including forced lowering and start-up assistance, activation 3x brake
Braking system
2-line compressed air braking system
Color-coded line routing for easy maintenance
Spring brake parking brake
2 fail-safe coupling heads at the front, without connecting line
EBS, electronic braking system with EBS socket at the front, without connecting cable
Attention: The trailer may only be towed by tractor units that ensure the effectiveness of the ABS!
With raising and lowering valve
Vehicle - Driving stability system
Axle load detection via EBS-CAN bus signal, for display via the display in the driver's cab, truck must be prepared accordingly, no truck installation (no calibrated scale)
Wheels and tires
385/65 R22.5, manufacturer's choice
Steel rims, factory silver
Electrical system
24 volts, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red side marker lights at the rear
1 x 15-pole socket at the front, without connecting cable
Operating instructions
The specified total weight is technically possible, but depending on the load, the total weight may not be reached while complying with the permissible axle/support and saddle loads. (Poor driving and handling behavior may occur due to incorrect load distribution)
This vehicle may only be loaded with 20' tank containers that comply with ISO 668 and in particular ISO 1496-3! The tank containers must have "end-load-transfer areas"!
Country of registration / signs
Germany
Type approval according to EC 2007/46
24/7 service hotline
Prepared for single-row license plate holder
Warning sign according to ECE - 70
Acceptance according to ADR, according to 9.1.1.2 of the ADR, EX/II, EX/III / Vehicle registration certificate for the transport of certain dangerous goods (ex.B3) with warning sign on the rear, not valid for substances according to UN 0

Kuulutus tõlgiti automaatselt. Tõlkevigu võib esineda.