Madallaadur

Fliegl DTS 300 P mit Radmulde

Further information
Chassis low loader trailer
Welded steel construction
1st pair of wheel recesses after steel platform recessed in the tramline area, inclined towards the entrance, length at the bottom approx. 1400 mm, approx. 400 mm deep. Note!
Frame in main beam area 400 mm higher than wheel recess.
If machines are to be driven where the overall height is to be checked, we request a technical data sheet for the machine types with exact details (if overall height is exceeded -> customer risk, approval required), (depending on the ground clearance under the machines, inserts in the wheel recesses may be required by the customer).
Turntable with strong ball bearing slewing ring, storage box embedded in turntable front end
Folding rear support
2 wheel chocks with holder
Aluminum side bumper
Rear spray flaps across the entire width
Widenings can be extended to 3,000 mm (not in the rear slope)
(However, the track width of the construction machinery or vehicles to be transported must not exceed
outer frame width 2,550 mm)
Storage compartment for wooden planks in the middle of the cargo bed
Wooden planks 70 mm for widening to 3000 mm
Low loader lashing eyes
110 3 pairs of lashing points, 10 tons each, integrated in the floor at the front Incl.
6 pairs of lashing mushrooms at the top and sides, each 10 tons, embedded in the outer frame
1 x to neck area
remaining distributed in between Distance not greater than 1200 mm
1 x rear slope
5 pairs of stake pockets embedded in the outer frame, inside 70 x 40 mm, (can be converted to 5 to. ring lashing eyes, not included)
Towing equipment Trailer turntable
Drawbar with tested 40 mm drawbar eye
Axles + suspension
SAF drum brake axles
Axle/chassis laser-measured Reduction in tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings
Brake system
2-line compressed air brake system
Colored line routing for easy service.
Spring-loaded parking brake
2 swap-proof coupling heads at the front, with connecting lines to the motor vehicle,
ABS and ALB, with ABS plug at the front, with connecting cable,
Attention: The trailer may only be towed by towing vehicles
which guarantee the effectiveness of the ABS!
Wheels and tires
235 / 75 R 17,5
at the choice of the manufacturer
Twin steel rims, factory silver
Electrical system
24 volt, multi-chamber lights, amber LED lighting at the sides
2 white position lights at the front
2 white/red lane departure lights at the rear
2 x 7-pin interchangeable plugs at the front, with connecting cable,
1 LED rotating beacon with holder, switched via parking light (removable light)
2 pairs of warning signs, double LED illuminated and extendable to 3,000 mm
Floor
Front area steel floor, incl.
Afterwards with 70 mm softwood floor, steel/checker plate covering in the wheel housing area
Rear slope with 70 mm softwood floor
Low loading area incl. rear slope 8 200 mm
Drive-on ramps
Steel ramps 2,800 mm long, 750 mm wide, can be moved sideways
Iaedpfx Abei Ri Ryefsl
covered with wood
with spring lift support
Operating instructions
With an axle load of 10,000 kg, a special permit is required, only indivisible loads possible!!!
The specified total weight is technically possible; depending on the load, the total weight may not be reached if the permissible axle/support and fifth-wheel loads are observed.
cannot be achieved. (Poor driving and trailing behavior possible due to incorrect load distribution)
Country of registration / plates
Country of registration: Germany Incl.
with

Kuulutus tõlgiti automaatselt. Tõlkevigu võib esineda.